Mitsubishi MOTORS L200 1996, Руководство по ремонту, Страница: 1432 / 1723

SRS –
Air Bag Module Disposal Procedures
52B-35
NOTE
If the clock spring connector is disconnected from the
body wiring harness, both electrodes of the clock spring
connector will be automatically shorted to prevent
unintended deployment of the air bag due to static
electricity, etc.
4. Connect two wires, each six meters or longer, to the two
leads of SRS air bag adapter harness A and cover the
connections with insulation tape. The other ends of the
two wires should be connected to each other
(short-circuited), to prevent sudden unexpected
deployment of the air bag.
5. Connect the clock spring 2-pin connector (red) to SRS
air bag adapter harness A and pass the deployment wires
out of the vehicle.
6. At a location as far away from the vehicle as possible,
disconnect the two connected wires from each other, and
connect them to the two terminals of the battery (which
has been removed from the vehicle) to deploy the air
bag.
Caution
1.
Before deploying the air bag in this manner, first
check to be sure that there is no one in or near
the vehicle. Wear safety glasses.
2. The inflator will be quite hot immediately following
the deployment, so wait at least 30 minutes to
allow it to cool before attempting to handle it.
Although not poisonous, do not inhale gas from
air bag deployment.
See Deployed Air Bag Module Disposal
Procedures (P.52B-38.) for post-deployment
handling instructions.
3. If the air bag module fails to deploy when the
procedures above are followed, do not go near
the module. Contact your local distributor.
SRS air bag
adapter
harness A
MB686560
Connection
6 m or
longer
Two wires
Insulation
tape
SRS air bag adapter
harness A
MB686560
2-pin connector (red)
Deployment wires
Wires 6m
or longer
Vehicle battery