Mitsubishi MOTORS L200 1996, Руководство по ремонту

Страница: 1334 / 1723

EXTERIOR –
Stripe Tape
51-16
Align tape notch
to press line
Align tape notch to press line
Press
line
Front body
end line
Press
line
49 mm
Press line
Door outside
handle
Point C
Align tape end to door
outside handle
Section
c – c
Tape end
Tape end
Point D
Door end line
Door opening line
Align tape notch to
door opening line
Section
d – d
Bend the stripe
tape securely
Point E
Rear body end line
Align tape notch to
rear body end line
Align tape notch
to press line
Bend the stripe
tape securely
Point F
Align tape notch
to press line
Section
e – e
c
d
e
c
d
e
2. Use the special tool to press on the tape, beginning at
the centre and moving evenly to both the top and bottom,
in order to remove any trapped air bubbles.
Caution
1.
If the special tool slides to the side, there will
be slack at the end of the tape, causing wrinkles,
and the tape may deviate from the correct
application position.
2. If the tape is not applied properly, it may come
off later.
3. Pull the tape off straight and slowly.
4. If there are any air bubbles in the tape after the application,
use a sewing needle to make small holes in the bubbles,
and use the corners of the spatula to press the air out.
30
_
– 45
_
MB990528
Tape
Good
Bad