Mitsubishi MOTORS L200 1996, Руководство по ремонту, Страница: 884 / 1723

FRONT AXLE –
Differential Carrier
26-51
Standard value:
Bearing division Bearing lubrication Rotation torque
New None (With
anti-rust agent) 0.5 – 0.7 Nm
New or reusing Gear oil applied 0.3 – 0.4 Nm
NOTE
The special tool cannot be turned a full revolution, so
turn it several times within the range of movement to
run in the bearing, and then measure the rotation torque.
4. Clean the side bearing hub.
5. Install the special tools to the side bearing hub of the
gear carrier, and then install the bearing cap.
NOTE
Always check that the notch is in the shown position
and that the special tools are touching firmly against the
side bearing hub.
6. Use a thickness gauge to measure the clearance (A)
between the special tools.
7. Remove the special tools (MB991170, MB990904).
8. Use a micrometer to measure the special tool in the places
(B, C) shown in the illustration.
9. Install the bearing cap, and then use a cylinder gauge
and micrometer to measure the inside diameter (D) of
the bearing cap as shown in the illustration.
10. Calculate the thickness (E) of the required drive pinion
front shim by the following formula, and then select a
shim which most closely matches this thickness.
E = A + B + C–1/2D–91.0
MB990685
MB990326
Notch
MB991170
Thickness gauge MB990904
A
B
C
D
Bearing cap