Mitsubishi MOTORS L200 1996, Руководство по ремонту

Страница: 1590 / 1723

CHASSIS ELECTRICAL –
Radio and Tape Player
54-79
2. Return the power supply from the battery to the normal
condition.
3. Turn the ignition key to the “ACC” or “ON” position.
4. Press the POWER button, and “CODE” will be displayed.
5. Press No.1 through No.4 memory select button to set
the four-digit security code shown on the card.
Every time each digit key is pressed, the figure changes
as follows: 0
1 2..........9 0
6. Press the BAND button, and a beep will be heard and
the radio and tape player will work.
7. If the security code is not accepted, “1 ERROR” is
displayed. In a few minutes, it will change to “CODE”.
Then repeat the steps 5 and 6.
NOTE
(1) If an incorrect security code is input, the anti-theft
system will allow three attempts at most to input the
correct code.
(2) The second error is displayed as “2 ERROR”. When
the third error is made, “3 ERROR” is displayed and
then the display changes to “OFF”. If this should occur,
the unit will not work any more.
(3) To input the security code again, turn the ignition
switch to the ACC or ON position and wait for one
hour when “OFF” is displayed. After “OFF” disappears
on the display and changes into “CODE”, the security
code can be input again.
5-minute operation mode
To facilitate replacement or check, the radio and tape player
can be operated for five minutes without inputting the security
code.
1.
Press the POWER button and No.5 memory select button
together to operate the radio and tape player.
2. In five minutes the unit will not be able to work, and
“CODE” will be displayed to indicate that the security
code can be input again.
BAND button
Memory select
button
POWER button
Display
1 2 3 4 5 6
POWER button
No.5 memory
select button