Mitsubishi MOTORS L200 1996, Руководство по ремонту

Страница: 1416 / 1723

SRS –
Post-collision Diagnosis
52B-19
POST-COLLISION DIAGNOSIS
52400110154
To inspect and service the SRS after a collision (whether
or not the air bag has deployed), perform the following steps.
SRS DIAGNOSIS UNIT MEMORY CHECK
1. Connect the MUT- II to the diagnosis connector (16-pin).
Caution
Turn off the ignition switch before connecting or
disconnecting the MUT-
II.
2. Read (and write down) all displayed diagnosis codes.
(Refer to P. 52B-6.)
NOTE
If the battery power supply has been disconnected or
disrupted by the collision, the MUT-
II cannot communicate
with the SRS diagnosis unit. Inspect and, if necessary,
repair the body wiring harness before proceeding further.
3. Read the data list (fault duration and how many times
memories are erased) using the MUT-
II
.
Data list
No. Service Data Item Applicability
91 How long a problem has lasted Maximum time to be stored: 9999 minutes
(approximately 7 days)
92 Number indicating houw often the memory is cleared Maximum time to be stored: 250
4. Erase the diagnosis codes and after waiting 5 seconds
or more read (and write down) all displayed diagnosis
codes. (Refer to P.52B-6.)
REPAIR PROCEDURE
WHEN AIR BAG DEPLOYS IN A COLLISION.
1. Replace the following parts with new ones.
D
SRS diagnosis unit (SDU) (Refer to P. 52B-26.)
D
Air bag module (Refer to P. 52B-28.)
D
Front impact sensors (Refer to P. 52B-23.)