Mitsubishi MOTORS L200 1996, Руководство по ремонту

Страница: 217 / 1723

15
A02S0003
8. Apply a small amount of engine oil to the O-ring of the new
oil filter
9. Once the O-ring of the oil filter is touching the flange, use
the respective tool in the following table to tighten to the
specified torque.
10. Install the drain plug and refill engine oil. (Refer to P.12-3,
Engine Oil Replacement.)
Specified Engine Oil (API classification):
<6G7> SG or higher
<4D5> CD or higher
Total quantity (Includes volume inside oil filter and oil
cooler):
<6G7> 4.5
ℓℓℓℓ
<4D5> 6.5
ℓℓℓℓ
11. Race the engine a few times, and check to be sure that no
engine oil leaks from the installation section of the oil filter.
Number Engine Tool Tightening torque
MD352626 6G7 MB991610 or equivalent tool Approx. 3/4 turn (14 Nm)
MD069782 4D5 MH061590 or equivalent tool Approx. 5/8 turn (20 Nm)
MD326489 Approx. 3/4 turn (22 Nm)
A0210006
OIL LEVEL WARNING SYSTEM CHECK
12100200054
1. Check that the proper amount of oil has been filled.
2. When the ignition switch is turned to ON (do not start the
engine), check that the oil level warning lamp illuminates.
NOTE
If the oil level warning lamp does not illuminate, the cause
is probably a blown lamp, or a malfunction in the relay.
DEN0086
3. When the engine is started, check that the oil level warning
lamp turns off.
If the oil level warning lamp will not go out, disconnect the
connector of the oil level relay and measure the voltage of
the No.1 terminal on the harness side of the connector
while idling the engine in order to confirm that it is the
same as the battery voltage.
NOTE
(1) If the voltage at the connector is the same as the
battery voltage, the problem is probably a malfunction
of either the oil level relay or the oil level sensor.
’99 PAJERO SPORT Workshop Manual chassis
ENGINE LUBRICATION –
On-vehicle Service
12-5
O-ring
Commercially-available tool
<Correct>
<Incorrect>
Engine oil level
relay
Engine oil level sensor connector
(Harness side)