Mitsubishi MOTORS L200 1996, Руководство по ремонту

Страница: 1121 / 1723

8
With the MUT-II
Connect the MUT-II to the diagnosis connector (16-pin), then erase the diagnosis codes.
Caution
Turn the ignition switch off before connecting or disconnecting the MUT-II.
When diagnostic trouble codes (Nos. 21 to 24) (for vehicle wheel speed sensor system failures) occur,
normal MUT-II operation may not erase those codes. In that case, erase the diagnostic trouble codes
using the following procedures.
1. Perform erasing of the diagnostic trouble codes by special operation of the brake pedal. (See erasing
procedure for the diagnostic trouble codes without use of the MUT-II.)
2. Turn the ignition switch OFF.
3. Perform erasing of the diagnostic trouble codes by use of the MUT-II.
Without the MUT-II
1. Stop the car.
2. Place the stop lamp switch to ON (with brake pedal depressed).
3. Under the condition of 1 and 2 above, turn the ignition switch ON. After that, place the stop lamp
switch to OFF (with brake pedal released) within 3 seconds, and cycle the stop lamp switch ON and
OFF ten times consecutively.
NOTE:
When ABS-ECU stops functioning through the fail-safe mechanism, erasing of the diagnostic troubl
codes cannot be performed.
Ignition switch
Stop lamp switch
ABS warning lamp
Diagnostic trouble code memory
4. Ensure that the diagnostic trouble codes have been erased. When diagnostic trouble codes (Nos. 21
to 24) (for vehicle wheel speed sensor system failures) occur, the above procedures may not eras
those codes. In that case, turn the ignition switch OFF, then repeat steps 1 to 3 above.
<New>
OFF
ON
OFF
ON
OFF
ON
10th
With-
in 1s
8th
With-
in 1s With-
in 1s With-
in 1s With-
in 1s
6th
3rd
AW0558AS
1s
Within 3
seconds
With-
in 1s With-
in 1s With-
in 1s
9th
7th 5th 4th 2nd
With-
in 1s With-
in 1s
Erasing completed
1st