Mitsubishi MOTORS L200 1996, Руководство по ремонту, Страница: 1668 / 1723

– Compressor and Tension Pulley
HEATER, AIR CONDITIONER
AND VENTILATION
55-31
REMOVAL SERVICE POINTS
A
A
"
DRIVE BELT REMOVAL
1. Loosen the nut “A” for holding.
2. Loosen the bolt “B” for adjustment.
3. Remove the drive belt.
A
B
"
SUCTION HOSE, DISCHARGE HOSE
DISCONNECTION
Plug the disconnected hose and the compressor nipple not
to let foreign matter get into them.
Caution
Seal the hoses completely, otherwise the compressor
oil and receiver will absorb water vapour easily.
A
C
"
COMPRESSOR REMOVAL
When doing this work, be careful not to spill the compressor
oil.
INSTALLATION SERVICE POINT
"
A
A
COMPRESSOR INSTALLATION
If a new compressor is installed, first adjust the amount of
oil according to the procedures described below, and then
install the compressor.
(1) Measure the amount (X m
) of oil within the removed
compressor.
(2) Drain (from the new compressor) the amount of oil
calculated according to the following formula, and then
install the new compressor.
New compressor oil amount
180 m – X m = Y m
NOTE
(1) Y m
indicates the amount of oil in the refrigerant
line, the condenser, the evaporator etc.
(2) When replacing the following parts at the same times
as the compressor, subtract the rated oil amount of
the each part from Y m
and discharge from the
new compressor.
Quantity
Evaporator: 50 m
Condenser: 30 m
Suction hose: 10 m
Receiver: 10 m
<4G6>
<4D5>
A
B
A
B