Mitsubishi MOTORS L200 1996, Руководство по ремонту

Страница: 867 / 1723

FRONT AXLE –
Drive Shaft
26-34
5. Place the B.J. boot band (small) against the projection
at the edge of the boot, and then secure it so that there
is a clearance left as shown by (A) in the illustration.
6. Use the special tool to crimp the B.J. boot band (small).
Caution
1.
Secure the drive shaft in an upright position and
clamp the part of the B.J. boot band to be crimped
securely in the jaws of the special tool.
2. Crimp the B.J. boot band until the special tool
touches the stopper.
7. Check that crimping amount (B) of the B.J. boot band
is at the standard value.
Standard value (B): 2.4 – 2.8 mm
<If the crimping amount is larger than 2.8 mm>
Readjust the value of (W) in step (4) according
to the following formula, and then repeat the
operation in step (6).
W = 5.5 mm – B
Example: If B = 2.9 mm, then W = 2.6 mm.
<If the crimping amount is smaller than 2.4 mm>
Remove the B.J. boot band, readjust the value
of (W) in step (4) according to the following
formula, and then repeat the operations in
steps (5) and (6) using a new B.J. boot band.
W = 5.5 mm – B
Example: If B = 2.3, then W = 3.2 mm.
8. Check that the B.J. boot band is not sticking out past
the place where it has been installed.
If the B.J. boot band is sticking out, remove it and then
repeat the operations in steps (5) to (7) using a new
B.J. boot band.
9. Fill the inside of the B.J. boot with the specified amount
of the specified grease.
Specified grease: Repair kit grease
Amount to use: 125 g
A
B.J. boot
B.J. boot band
(small)
Projection
MB991561
B