Mitsubishi MOTORS L200 1996, Руководство по ремонту

Страница: 658 / 1723

ENGINE ELECTRICAL –
Charging System
16-14
DISASSEMBLY SERVICE POINTS
A
A
"
FRONT BRACKET REMOVAL
1. Remove the bolts.
2. Insert a flat-tipped screwdriver between front bracket and
stator core and pry downwards.
Caution
Do not insert a screwdriver too deep, as the stator
coil will be damaged.
A
B
"
PULLEY REMOVAL
With the pulley side facing up, hold the rotor in a vice and
remove the pulley.
Caution
Use care not to damage the rotor.
A
C
"
STATOR REMOVAL/REGULATOR ASSEMBLY
REMOVAL
1. When removing stator, unsolder three stator leads
soldered to main diodes on rectifier.
2. When removing rectifier from brush holder, unsolder two
soldered points to rectifier.
Caution
1.
When soldering or unsoldering, use care to make
sure that heat of soldering iron is not transmitted
to diodes for a long period. Finish soldering or
unsoldering in as short a time as possible.
2. Use care that no undue force is exerted to leads
of diodes.
REASSEMBLY SERVICE POINT
"
A
A
REGULATOR ASSEMBLY INSTALLATION
Install the regulator assembly, insert a wire into the rear bracket
hole while pushing in the brush, and hold the brush.
NOTE
Inserting a wire holds the brush, so that the rotor can be
replaced easily.
Soldered
Wire