Mitsubishi MOTORS L200 1996, Руководство по ремонту

Страница: 952 / 1723

REAR AXLE –
Differential Case Assembly
27-48
DISASSEMBLY SERVICE POINT
A
A
"
SCREW REMOVAL
1. Check the mating marks.
NOTE
The mating marks are represented by one of the following
methods.
(1) Engraving by a punch or electric pen.
(2) Identical arabic numerals.
2. Loosen the mounting screws for differential case (A) and
(B) evenly step by step.
3. Separate differential case (B) and differential case (A),
and take out the parts inside. Do not confuse the left
and right spring plates, spring discs, friction plates and
friction discs for further reassembly.
REASSEMBLY SERVICE POINTS
"
A
A
DIFFERENTIAL CASE (B) INSTALLATION
Before assembly, use the following method to adjust the
clearance between the spring plates and differential cases
(for adjustment of the clutch plate friction force), and to adjust
the end play of the side gear when installing the internal
components into the differential case.
1. Arrange the two (each) friction discs and friction plates
for each side, one on top of another, as shown in the
figure, combining them so that the difference in thickness
between the left and the right is the standard value.
Standard value: 0 – 0.05 mm
NOTE
Two types of replacement parts are available:
Friction disc (with thicknesses of 1.6 mm and 1.7 mm)
Friction plate (with thicknesses of 1.75 mm and 1.85 mm)
2. Place the spring plates together as shown in the
illustration, and use a micrometer to measure the
thickness. Place the parts together in the combination
that gives the least difference in thickness between the
two sets.
NOTE
If replacing with new parts, the thickness of the spring
plates should be 1.75 mm.
Mating marks