Mitsubishi MOTORS L200 1996, Руководство по ремонту

Страница: 1123 / 1723

10
Without the MUT-II
1. Use the special tool to earth terminal (1) (diagnosis control terminal) of the diagnosis connector.
(Refer to GROUP 00 – How to Use Troubleshooting/Inspection Service Points.)
2. Stop the engine.
3. Turn on the stop lamp switch.
4. After carrying out steps 1. To 3., turn the ignition switch to ON. Within 3 seconds after turning the
ignition switch to ON, turn off the stop lamp switch (release the brake). Then, turn the stop lamp
switch; on and off a total of 10 times.
NOTE
If the ABS-ECU function has been stopped because of fail-sage operation, it will not be possible t
erase the diagnosis codes.
Ignition switch
Stop lamp switch
ABS-ECU warming lamp
ABS-ECU memory
<Added>
5. Ensure that the diagnostic trouble codes have been erased.
When diagnostic trouble codes (Nos. 21 to 24) (for vehicle wheel speed sensor system
failures) occur,the above procedures may not erase those codes. In that case, turn the ignition
switch OFF, then repeat steps 1 to 4 above.
35B-5
ABS <4WD> - Troubleshooting
OFF
ON
OFF
ON
OFF
ON
With-
in 1s
With-
in 1s
4th
5th
AW0558AS
7th 3rd
9th
8th 6th 2nd
1s
With-
in 1s
Within 3
seconds
With-
in 1s With-
in 1s
With-
in 1s
With-
in 1s
With-
in 1s With-
in 1 s
Erasing of
ABS-ECU
diagnosis
codes
complete
1st
10th
With-
in 1s