Mitsubishi MOTORS L200 1996, Руководство по ремонту, Страница: 1070 / 1723

ABS <2WD> –
On-vehicle Service
35B-23
ON-VEHICLE SERVICE
35200150108
BLEEDING
Caution
Use the specified brake fluid. Avoid using a mixture of
the specified brake fluid and other fluid.
Specified brake fluid: DOT3 or DOT4
MASTER CYLINDER BLEEDING
The master cylinder used has no check valve, so if bleeding
is carried out by the following procedure, bleeding of air from
the brake pipeline will become easier. (When brake fluid is
not contained in the master cylinder.)
(1) Fill the reserve tank with brake fluid.
(2) Keep the brake pedal depressed.
(3) Have another person cover the master cylinder outlet
with a finger.
(4) With the outlet still closed, release the brake pedal.
(5) Repeat steps (2) – (4) three or four times to fill the inside
of the master cylinder with brake fluid.
BRAKE PIPE LINE BLEEDING
Start the engine and bleed the air in the sequence shown
in the figure.
Caution
Be sure to install a filter to the master cylinder reservoir
tank when supplying brake fluid.
DISC BRAKE PAD CHECK AND REPLACEMENT
35200280012
NOTE
The brake pads have wear indicators that contact the brake
disc when the brake pad thickness becomes 2 mm, and emit
a squealing sound to warn the driver.
1. Check brake pad thickness through caliper body check
port.
Standard value: 10 mm
Limit: 2.0 mm
Caution
1.
When the limit is exceeded, replace the pads at
both sides, and also the brake pads for the wheels
on the opposite side at the same time.
2. If there is a significant difference in the
thicknesses of the pads on the left and right sides,
check the sliding condition of the piston, lock
pin and guide pin.
( ): R.H. drive vehicles
3 (4)
1*
4 (3)
2
Load sensing
proportioning
valve
When new When worn
Pad
Wear indicator
Brake disc