Mitsubishi MOTORS L200 1996, Руководство по ремонту

Страница: 1192 / 1723

STEERING –
Manual Steering Gear Box
37A-23
"
C
A
MAINSHAFT ASSEMBLY INSTALLATION
Apply gear oil to the tooth surfaces and sliding surfaces,
and insert the mainshaft assembly and bearings into the gear
housing.
"
D
A
MAINSHAFT STARTING TORQUE ADJUSTMENT
1. Install the end cover and adjusting shim(s) to the gear
housing and then tighten to the specified torque.
Standard value: 0.49 – 0.78 Nm
2. Measure the mainshaft starting torque by using the special
tools.
3. If the measured value is not within the standard value,
adjust by changing the adjusting shim(s).
4. Remove the shim(s) to increase starting torque, or add
shim(s) to reduce.
"
E
A
CROSS-SHAFT AXIAL PLAY ADJUSTMENT
1. Install the adjusting spacer to the adjusting bolt and
measure the cross-shaft axial play.
Standard value: 0.05 mm or less
2. If the measured value is not within the standard value,
adjust by changing the adjusting spacer.
"
F
A
MAINSHAFT TOTAL STARTING TORQUE
ADJUSTMENT
Lubricate the bearings and gear teeth of each shaft.
1.
Move the ball nut of the mainshaft to the centre position
(straight ahead position).
Caution
Do not damage the cross-shaft oil seal.
2. Turn the adjusting bolt 2 or 3 times until the tooth surfaces
are in contact.
3. Measure the mainshaft total starting torque.
(1) Secure the flange part of the gear box housing in
a vise.
(2) Measure the mainshaft total starting torque by using
the special tools.
Standard value: 0.98 – 1.47 Nm
NOTE
The mainshaft should rotate smoothly across the
entire range.
MB991006 or
MB990228
MB991151
MB991006 or
MB990228
MB990685