Mitsubishi MOTORS L200 1996, Руководство по ремонту

Страница: 1463 / 1723

3
AIR BAG MODULES AND CLOCK SPRING
Caution
1. Disconnect the negative battery cable from
the battery and tape the terminal
Caution
Wait at lest 60 seconds after disconnecting
the battery cable before doing any further
work. (Refer to P.52B-4.)
2. Never attempt to disassemble or repair the
air bag module or clock spring. If faulty,
replace it.
3. Do not drop the air bag module or clock
spring or allow contact with water, grease
or oil. Replace it if a dent, cracks deforma-
tion or rust are detected.
4. The air bag modules should be stored on a
flat surface and placed so that the pad
surface is facing upward.
Do not place anything on top of the air bag
modules.
5. Do not expose the air bag module to
temperature over 93° C.
6. After deployment of an air bag, replace the
clock spring.
7. Wear gloves and safety goggles when
handling an air bag that has deployed.
8. An undeployed air bag module should only
be disposed of in accordance with the
specified procedures. (Refer to P.52B-30)
REMOVAL AND INSTALLATION
<Air bag module (Driver’s side), Clock spring>
52B-24
SRS - Air Bag Modules and Clock Spring
52400230010
After deployment of an air bag, replace the
air bag modules. Check the clock spring,
and if faulty, replace it with a new part.
<Incorrect>
<Correct>
52400240105
Pre-removal Operation
Set the steering wheel and the front wheels to the
straight ahead position, and then remove the ignition
key.
Clock spring removal steps Air bag module (Driver’s side )
removal steps
A
B
E
D
C
B
A
•
Post-installation inspection
•
Negative (-) battery cable connection
1. Air bag module (Driver’s side)
2. Steering wheel
3. Column cover lower
4. Clock spring and body wiring
harness connection
5. Clock spring
•
Pre-installation inspection
E
D
A
•
Post-installation inspection
•
Negative (-) battery cable connection
2. Air bag module (Driver’s side)
•
Pre-installation inspection
S19X0566