Mitsubishi MOTORS L200 1996, Руководство по ремонту

Страница: 67 / 1723

3
WHEN USING THE WARNING LAMP
1. Use the special tool to earth No.1 terminal (diagnosis control
terminal) of the diagnosis connector.
2. To check ABS system, remove the valve relay.
NOTE
That is because the valve relay is off and the warning lamp
remains illuminated if there is a fault in the ABS system.
3. Turn off the ignition switch.
4. Read out a diagnosis code by observing how the warning
lamp flashes.
Applicable systems
System name Warning lamp name
MPI Engine warning lamp
A/T Neutral position indicator lamp
ABS ABS warning lamp
Indication of diagnosis code by warning lamp
When the diagnosis code No.24 is output
When no diagnosis code is output*
NOTE
*: Even if the ABS system is normal, removing the valve relay causes the diagnosis code No.52 to be
output.
METHOD OF ERASING DIAGNOSIS CODES
WHEN USING THE MUT-II
Connect the MUT-II to the diagnosis connector and erase the diagnosis code.
Caution
Turn off the ignition switch before connecting or disconnecting the MUT-II.
WHEN NOT USING THE MUT-II
(1) Turn the ignition switch OFF.
(2) After disconnecting the battery cable from the battery (-) terminal for 10 seconds or more, reconnect
the cable
(3) After the engine has warmed up, run it at idle for about 15 minutes.
00-8
GENERAL - How to Use Troubleshooting/Inspection Service Points
On
Off
0.5 sec. <MPI, A/T>
0.25 sec. <ABS>
Units
signal.
Tens signal Pause time
3 secs.
On
Off
1.5 sec.
0.5 sec.
0.5 sec.
Place
division
2 secs.
A03X0114
A03X0113
Diagnosis connector
MB991529
A00M0030
<Incorrect>
<Correct>
ON