Mitsubishi MOTORS L200 1996, Руководство по ремонту

Страница: 123 / 1723

ENGINE <4G6> –
Cylinder Head Gasket
11A-24
INSTALLATION SERVICE POINTS
"
A
A
CYLINDER HEAD GASKET INSTALLATION
1. Wipe off all oil and grease from the gasket mounting
surface.
2. Install the gasket to the cylinder block with the identification
mark facing upwards.
"
B
A
CYLINDER HEAD ASSEMBLY INSTALLATION
1. When installing the cylinder head bolts, the length below
the head of the bolts should be within the limit.
If it is outside the limit, replace the bolts.
Limit (A): 99.4 mm
2. Apply a small amount of engine oil to the thread section
and the washer of the cylinder head bolt.
3. Tighten the bolts by the following procedure.
Step Operation Remarks
1 Tighten to 78 Nm. Carry out in the order
shown in the illustration.
2 Fully loosen. Carry out in the reverse
order of that shown in the
illustration.
3 Tighten to 20 Nm. Carry out in the order
shown in the illustration.
4 Tighten 90
_
of a turn. In the order shown in the
illustration. Mark the head
of the cylinder head bolt
and cylinder head by paint.
5 Tighten 90
_
of a turn. In the order shown in the
illustration. Check that the
painted mark of the head
bolt is lined up with that of
the cylinder head.
Caution
1.
Always make a tightening angle just 90
_
. If it is less
than 90
_
, the head bolt will be loosened.
2. If it is more than 90
_
, remove the head bolt and repeat
the procedure from step 1.
Identification mark
(Engine oil)
4
1
6 7 9
Intake side
Exhaust side
2 3 5 8 10
Front of engine
Step 4
90
_
Painted mark
Step 5
90
_
Painted mark