Mitsubishi MOTORS L200 1996, Руководство по ремонту

Страница: 1248 / 1723

4
5. 4WD VEHICLES
If the measured value exceeds the limit, screw in the
steering gear box adjusting bolt until steering wheel free
play is within the range of standard value.
Caution
1.
Be sure to make the adjustment with the steering
wheel in the straight-ahead position.
2. If the adjusting bolt is overtightened, more
steering effort will be required, and return of the
wheel will be adversely affected.
MEASURING BALL JOINT AXIAL PLAY
E37FCAA
1. Hold the ball joint by using the special tool.
2. Set the scale of special tool to the upper limit (A),
compress the ball stud, and measure the axial play. The
measured displacement should be between the upper limit
(A) and the centre graduation (B).
Limit: 1.5 mm (0.06 in.)
3. If the measured displacement exceeds the centre
graduation (B), replace the ball joint.
CHECKING STEERING ANGLE
E37FDAA
1. Place the front wheel on a turning radius gauge and
measure the steering angle.
Standard value 2WD vehicles 4WD vehicles
0°
Inner wheel 37°
-3°
30°
0°
Outer wheel 30°20’ 27°
-3°
2. Adjust the steering angle of each wheel by turning the
stop bolt of the knuckle arm.
NOTE
On 4WD vehicles, after adjusting the steering angle,
mount the cap onto the jam bolt so that the edge of the slit
side of the cap and the head of the stop volt are flush and
face in the same direction, and then pack the head of the
stop volt with the specified grease.
Specified grease: Multipurpose grease SAE J310,
NLGI No. 2
Caution
Be sure that the toe-in is properly adjusted before
adjusting the steering angle.
CHECKING STEERING GEAR OIL LEVEL
(MANUAL STEERING)
E37FEAA
Remove the breather plug and check the oil level in the
steeing gear box by using a special gauge or a thin
screwdriver.
Standard value:
2WD vehicles 35 mm (1.4 in.)
4WD vehicles 30 mm (1.2 in.)
PWTE8614-B REVISED
37-14
STEERING – Service Adjustment Procedures
13B0006
13E108
13Y582
MB990948
13F006
12S611
13S756
Slit
Cap
Flush level
Followed by next page
13S075