Mitsubishi MOTORS L200 1996, Руководство по ремонту

Страница: 1268 / 1723

BODY –
Window Glass
42-16
INSTALLATION SERVICE POINTS
"
A
A
DUAL LOCK FASTENER/WINDSHIELD
INSTALLATION
1. When replacing the glass, temporarily set the glass against
the body, and place a mating mark on the glass and
body.
2. Use isopropyl alcohol to degrease the inside and outside
of the windshield glass and the body flanges.
3. Soak a sponge in the primer, and apply evenly to the
glass and the body in the specified places.
4. Apply the primer, and then let it dry for 3 to 30 minutes.
Caution
(1) The primer strengthens the adhesive, so be sure
to apply it evenly around the entire circumference.
However, a too thick application will weaken the
adhesive.
(2) Do not touch the coated surface.
5. Install the dual lock fasteners to the windshield in the
position shown in the illustration.
6. Install the dual lock fasteners to the body flange in the
positions that are corresponding to those on the
windshield.
7. Fill a sealant gun with adhesive. Then apply the adhesive
evenly around the windshield within 30 minutes after
applying the primer.
NOTE
Cut the tip of the sealant gun nozzle into a V shape
to simplify adhesive application.
8. Align the mating marks on the glass and the body, and
lightly press the windshield glass evenly so that it adheres
completely.
9. Use a spatula or the like to remove any excessive
adhesive. Then clean the surface with isopropyl alcohol.
Try not to move the vehicle until the adhesive sets.
10. Wait 30 minutes or more, and then test for water leakage.
Caution
(1) Do not move the vehicle unless absolutely
necessary.
(2) When testing for water leakage, do not pinch the
end of the hose to spray the water.
Dual lock fastener installation position
Glass side
Body side
<Upper> <Lower>
<Upper>
<Lower>
Edge of cowl top
outer panel
Notch
Edge of
glass
Edge of ce-
ramic section
Edge of ceramic section
Edge of ceramic section
Edge of glass
Edge of roof out-
er panel
Notch
10
mm
15
mm
10 mm
15 mm