Mitsubishi MOTORS L200 1996, Руководство по ремонту

Страница: 1180 / 1723

STEERING –
On-Vehicle Service
37A-11
DRIVE BELT TENSION CHECK
(POWER STEERING)
37200190074
Refer to GROUP 11A and B – On-vehicle Service.
FLUID LEVEL CHECK (POWER STEERING)
37200200098
1. Park the vehicle on a flat, level surface, start the engine,
and then turn the steering wheel several times to raise
the temperature of the fluid to approximately 50 – 60
_
C.
2. With the engine running, turn the wheel all the way to
the left and right several times.
3. Check the fluid in the oil reservoir for foaming or milkiness.
Check the difference of the fluid level when the engine
is stopped, and while it is running. If the change of the
fluid level is 5 mm or more, air bleeding should be done.
FLUID REPLACEMENT (POWER STEERING)
37200210091
1. Raise the front wheels on a jack, and then support them
with rigid racks.
2. Disconnect the return hose connection.
3. Connect a vinyl hose to the return hose, and drain the
oil into a container.
4. On vehicles with a petrol engine, disconnect the
high-tension cable. On vehicles with a diesel engine,
remove the fuel cut valve connector attached to the
injection pump.
Caution
Be careful not to position the high-tension cable near
the delivery pipe.
5. While operating the starting motor intermittently, turn the
steering wheel all the way to the left and right several
times to drain all of the fluid.
6. Connect the return hoses securely, and then secure it
with the clip.
7. Fill the oil reservoir with the specified fluid up to the lower
position of the filter, and then bleed the air.
Specified fluid:
Automatic transmission fluid
DEXRON or DEXRON
II
Fluid level change: Within 5 mm
While engine
running While engine
stopped
Return hose
Vinyl hose