Mercury Racing VesselView, Инструкция по установке, калибровке и эксплуатации

Страница: 43 / 190

Section 2 - Initial Setup and Calibration
Page 36 90-8M8022154 APRIL 2008
viii.Press the down arrow on the arrow trackpad to select the next tank in the table.
NOTE: As you progress through the listed tanks in the table the tank successfully calibrated
will change to blue text.
32803
ix. Repeat steps ii through viii for each tank.
x. Once all tanks have been calibrated (identified as blue text), end the calibration
process by selecting the
X
button.
NOTE: Upon completing any change/customization to VesselView a blue pop‑up message
will appear as a reminder to save your session. Refer to
Section 1 - Saving Settings
. To
save time, it is recommended that all session changes be saved before holding
X
button
while keying ALL engines off.
xi. If you are done calibrating the tanks, press the right arrow on the arrow
trackpad to continue to the "TAB SETUP" screen.
Tab Setup and Calibration
For vessels equipped with a tab or tabs, VesselView will need to be calibrated to the tab
sensor.
VesselView does not display the tab chart for power packages without tabs. Refer to
Section 4 - Trim/Tab Pop-Up (Settings)
.
The tab position sensor changes voltage (current actual %) as the tab is raised or lowered.
Changing the actual % value calibrates the tab level indicator to the tab position sensor.
To compensate for sensitivity of the tab position sensor, select the positions (100 = Down,
50 = Level, and 0 = Up) and adjust the actual % value to match the current actual % for
that known tab position.
NOTE: The "TABS" screen shows up to two tabs for a starboard and port setup or just a
center tab for a single tab setup. The "TABS" screen shown is for a two tab configuration.