Mercury Racing VesselView, Инструкция по установке, калибровке и эксплуатации

Страница: 89 / 190

Section 4 - Main Menu
Page 82 90-8M8022154 APRIL 2008
If a sensor is removed from the system after initial configuration, VesselView will start to
show faults for the removed sensor. To stop the fault message, perform the following
procedure. VesselView will rescan for sensors, and because the removed sensor no longer
exists, the fault message will go away.
1. The factory reset screen will ask you to "CHOOSE RESET TYPE". The two types of
resets are:
•
"RESET SETTINGS" ‑ This will reset VesselView to factory defaults.
• "RESET SENSOR DETECTION" ‑ This will scan the VesselView network for any
recently removed or installed sensors.
2. Use the left or right arrow on the arrow trackpad to highlight "RESET SENSOR
DETECTION".
3. Press the check button to confirm. A yellow pop‑up message will appear asking "ARE
YOU SURE YOU WANT TO RESET SENSOR DETECTION?".
a
b
27209
a - Reset sensor detection
b - Pop‑up message
4. Press the check button to continue or the
X
button to go back to the previous screen.
By pressing the check button, VesselView will reset the sensor detection, restart and
return to the engine status screen. All sensors connected before the reset will have
been detected and data will display in their appropriate screens.
Save Configuration
The "SAVE CONFIGURATION" screen is used to export selected configuration settings to
a USB memory stick for use with other VesselView units or for quick recovery of stored
configuration settings. This saves time by importing a configuration without having to
complete the entire setup wizard and other calibrations. To save your current
configurations, press the menu button until the "Main" menu appears, then "Calibrate" >
"Save Configs". Press the check button to open the "SAVE CONFIGURATION" screen.
IMPORTANT: The VesselView unit will recognize USB memory sticks of version 1.1 or a
USB memory stick of version 2.0 that is stated to be backwards compatible to version 1.1.
The VesselView unit will not recognize memory sticks that are only version 2.0 compatible.
IMPORTANT: Configuration settings saved to a USB memory stick are compiled into one
data file. Only one file can exist in the root of the USB memory stick. VesselView will not
recognize multiple import files.