Mercury Racing VesselView, Инструкция по установке, калибровке и эксплуатации

Страница: 12 / 190

Section 1 - Getting Started
90-8M8022154 APRIL 2008 Page 5
• Performs other functions as described in the on‑screen prompts.
Propulsion, Vessel, and Environment Buttons
• Opens the last screen viewed in the particular category.
• Toggles through the available category screens.
Brightness and Alarm Button
• Opens the screen brightness control for brightness adjustment of the VesselView
screen (when no faults are present).
• Enables quick access to the "ACTIVE ALARMS" screen where active faults and their
details are shown (when faults are present).
Menu Button
• Opens the menu panel of the active category.
• Toggles between the "Main" menu and the menu of the active category.
Turning the VesselView Unit On or Off
The VesselView unit automatically turns on when the key switch for any engine connected
to the unit is turned to the "RUN" position.
VesselView enters suspend mode 48 hours after the key switches for all engines connected
to the VesselView unit are turned to the "OFF" position. When any engine key switch is
turned to the "RUN" position again, VesselView quickly displays the last active screen.
To shut down the VesselView unit completely for storage or to save configuration session
changes, press the
X
button while turning the engine key switches to the "OFF" position.
Do not interrupt power to the unit while it displays the powering off screen. If power is
interrupted while VesselView is shutting down, changes made during that session may be
lost. When any engine key switch is turned to the "RUN" position again, VesselView
displays the last active screen after it completes the boot sequence.
IMPORTANT: If the battery switches are turned off, the VesselView unit will shut down
immediately, while this will not damage the unit, all session configuration changes made
since the last configuration save will be lost.
NOTE: When not in use, cover the VesselView unit with its protective cover to prevent the
screen from becoming damaged.
During the initial startup sequence for VesselView, a setup wizard screen appears,
prompting you to enter the initial setup for the unit. If this happens, follow the procedures in
Section 2 - Setup and Calibration
. This setup wizard does not return once completed
unless a factory reset is performed.
Restarting VesselView
At any time you can restart VesselView without the loss of any information or configuration
changes.
To restart VesselView, press and hold the
X
button and the check button at the same time
until the system restarts. VesselView will display the last active screen after it completes
the boot up cycle.
Cleanliness and Care of Product
Clean the VesselView screen with water and a soft cloth. Do not use detergents. When not
in use, cover the VesselView unit with its protective cover to prevent the screen from
becoming damaged.