Mercury Racing VesselView, Инструкция по установке, калибровке и эксплуатации

Страница: 75 / 190

Section 4 - Main Menu
Page 68 90-8M8022154 APRIL 2008
NOTE: As you progress through the listed tanks in the table the tank successfully calibrated
will change to blue text.
32803
10. Repeat steps ii through ix for each tank.
11. Once all tanks have been calibrated (identified as blue text), end the calibration process
by selecting the
X
button.
NOTE: Upon completing any change/customization to VesselView a blue pop‑up message
will appear as a reminder to save your session. Refer to
Section 1 - Saving Settings
. To
save time, it is recommended that all session changes be saved before holding
X
button
while keying ALL engines off.
TANK CALIBRATION USING FILL TANK METHOD
The fill tank method requires that you fill tank in intervals until full. This method is used
primarily for irregularly shaped tanks. This method is very similar to the "MANUAL" method
in that you will need to begin with an empty tank and fill the tank in quarter percent intervals.
The "FILL TANK" method takes you through the process step‑by‑step. It is important that
you do follow the set screens and not jump from empty (0%) to full (100%).
IMPORTANT: Follow the procedure; do not jump from empty (0%) to the full (100%) screen.
Not following the procedure will cause inaccuracy in your calibration.
FILL TANK METHOD PROCEDURE
1. Press the check button to select the tank to be calibrated.
32784