Mercury Racing VesselView, Инструкция по установке, калибровке и эксплуатации

Страница: 135 / 190

Section 5 - Propulsion Menu
Page 128 90-8M8022154 APRIL 2008
RESETTING PEAK VALUES
1. Press the check button while on this screen to access the reset your peak values dialog
box. The dialog box states "Would you like to Reset your Peak Values?".
33288
2. Press the check button to reset the peak values or the
X
button to cancel.
Viewing Trim/Tabs 2
The trim/tabs 2 screen displays the current speed and RPM, as well as the trim position
for up to three engines (triple setup maximum) and tab position for up to two tabs (a
starboard and port setup or just a center tab setup). There is two versions of the trim/tabs
2 screen; standard resolution and high resolution. To change the trim resolution, refer to
Section 4 - Trim/Tab Pop-Up (Settings)
.
IMPORTANT: Standard will show a range from 0 to 25 for the position of the trim or tab
pop‑up window. High resolution will show a range of 0 to 10 that offers a closer view of the
trim position. Standard resolution must be used when trailering the vessel in order to view
the full propulsion units trim position.
NOTE: When no trim or tab configuration is present, the space where the chart appears
will display (in large text) the inches/rev.
33092
STANDARD HIGH RESOLUTION
• The "P", "SC", and "S" bubbles will change in color when the engine key switch is turned
to the run position. They also will change in color when the engine's RPM's are
synchronized.
• RPM is displayed for all engines.
• Speed is displayed using pitot, paddle, or GPS sensor information.