Mercury Racing VesselView, Инструкция по установке, калибровке и эксплуатации

Страница: 101 / 190

Section 4 - Main Menu
Page 94 90-8M8022154 APRIL 2008
9. Press the down arrow on the arrow trackpad to proceed to the "INVERT STEERING"
field.
10. Invert steering is used to display the rudder angle position in the opposite direction from
default. The signal can be inverted to display the steering angle according to personal
preference. Press the left or right arrow on the arrow trackpad to choose "YES" or "NO"
to invert steering.
11. Once you have finished adjusting your sensors, press the check button to save the
session.
NOTE: Upon completing any change/customization to VesselView a blue pop‑up message
will appear as a reminder to save your session. Refer to
Section 1 - Saving Settings
. To
save time, it is recommended that all session changes be saved before holding
X
button
while keying ALL engines off.
Warnings
The "WARNINGS" screen enables you to turn the VesselView warning horn on or off and
to adjust the fuel level alarm values. Menu path: "Main" > "Settings" > "Warnings". Press
the check button to open the "WARNINGS" screen.
a
b
c
27143
a - Warning horn
b - Fuel critical level
c - Fuel low level
1. Upon entering the "WARNINGS" screen, the "WARNING HORN" field will be
highlighted in blue.
IMPORTANT: A fuel fault alarm will only occur if all fuel tanks on the vessel, connected to
VesselView, are sending a low fuel condition fault. If only one of many is sending a low fuel
condition fault, the VesselView will not identify the fault. The system looks at all tanks
defined as fuel and adds them all together into a single sum. The alarms are based off of
the sum of all fuel tanks.
NOTE: The VesselView warning horn can be turned "ON" or "OFF". By selecting "OFF",
all engine alarms will be heard through the key switch harness warning horn. By selecting
"ON", all alarms will be heard through the key switch harness horn and the VesselView
horn. For warning horn details, refer to
Section 4 - Alarms
.
2. Press the left or right arrow on the arrow trackpad to select either "ON" or "OFF".
3. Press the down arrow on the arrow trackpad to proceed to the "FUEL CRIT LEVEL"
field.