Mercury Racing VesselView, Инструкция по установке, калибровке и эксплуатации

Страница: 23 / 190

Section 1 - Getting Started
Page 16 90-8M8022154 APRIL 2008
Saving Settings
VesselView operates in sessions. Configuration changes can be made to a session but
when the VesselView unit is shutdown before saving it will lose those changes and go back
to its default settings (or last saved configuration settings). When changes are made to any
of the VesselView settings, whether for calibrating settings or for customization, those
changes need to be saved.
IMPORTANT: If the battery switches are turned off, the VesselView unit will shut down. All
session configuration changes made since the last configuration save will be lost.
When changing data in the fields of a screen, the screen may state to press the check
button to save the changes but in essence you are only saving those changes to the current
session. After a change is made to any VesselView screen press the check button to save
the changes made to the session or
X
button to cancel any changes.
Upon completing any change/customization to VesselView a blue pop‑up message will
appear as a reminder to save your settings (to save the session). To save time, it is
recommended that all session changes be saved before holding X button while keying ALL
engines off.
32769
IMPORTANT: Pressing the X button while turning the engine key switch "OFF" will save
the current session configuration settings and shut down VesselView.
When the engine key switches are turned back to the "RUN" position, VesselView will
perform a complete reboot that typically takes a few minutes. Due to the length of time to
reboot, it is advantageous to make all necessary configuration changes in a single session
and then save all changes at one time.
There are two methods to save configuration changes made in a session:
• Complete the setup wizard and press the check button. VesselView will save the
changes made in the setup wizard session, shutdown, and reboot.
• When changes have been made to VesselView, outside of the setup wizard, perform
the following procedure.
a.
While pressing the
X
button, turn the engine key switch to the "OFF" position. Be
sure to turn
all
engine key switches to their "OFF" position if multiple engines exist.
IMPORTANT: If any engine key switch is turned off after you have let go of the
X
button,
that particular engines session changes will be lost.
b. When any key switch is turned back to the "RUN" position, VesselView displays
the last active screen after it completes the boot up cycle. Though the data is
saved, only data for the engines that have their key switches turned to the "RUN"
position will be displayed.