Mercury Racing VesselView, Инструкция по установке, калибровке и эксплуатации

Страница: 29 / 190

Section 2 - Initial Setup and Calibration
Page 22 90-8M8022154 APRIL 2008
IMPORTANT: The "ENGINE TYPE" field may be blank when the "ENGINE SETUP" screen
initially appears. Before beginning this procedure, wait until an engine type appears in the
"ENGINE TYPE" field (this could take several seconds). If an engine type does not appear,
check that all engine ignition keys are in the "RUN" position and that the VesselView unit
is properly connected. For installation information, refer to Section 8 ‑ Installation and
Wiring.
1. Wait until an engine type appears in the "ENGINE TYPE" field. The "ENGINE TYPE"
field may take several seconds to detect the engine.
2. If the engine type is correct, proceed to step 5; otherwise, press the check button to
access the "ENGINE TYPE" field.
3. Press the left or right arrow on the arrow trackpad to scroll through the available engine
types.
4. Confirm your selection by pressing the check button.
5. If the number of engines is correct, proceed to step 8; otherwise, press the check button,
then the down arrow on the arrow trackpad to access the "NUMBER OF ENGINES"
field.
6. Press the right arrow on the arrow trackpad to increase the number of engines or the
left arrow to decrease the number of engines. The maximum number of engines is four.
IMPORTANT: Select the total number of engines installed, regardless of how many you
wish to display on VesselView.
7. Confirm your selections by pressing the check button.
8. Press the right arrow on the arrow trackpad to continue to the "DISPLAY SETUP"
screen.
NOTE: VesselView displays data from one engine by default.
NOTE: Although you may select up to four engines, VesselView only displays data for a
maximum of two diesel engines or three gasoline engines. Choosing four engines enables
you to add two more tanks; and to view the total fuel flow, fuel range, and drive link gauges
for all engines. All other data is displayed for the maximum number of engines allowed. It
is recommended that a second VesselView unit be used in a quad engine configuration.
Display Setup
The "DISPLAY SETUP" screen enables you to choose where the data for each engine is
displayed on VesselView. Typically, the engines are displayed left to right in the same order
as their physical locations port to starboard. Some helm configurations may require
different display settings. If you choose to display only one engine in a multi‑engine
application, VesselView displays aggregate data such as total fuel flow and range for all
engines, but displays engine specific data for only the engine selected for that display.
IMPORTANT: Do not choose the same screen location for more than one engine.
1. If the screen locations are correct, proceed to step 6; otherwise, press the check button
to access the "RIGHT SIDE" field.
NOTE: The "DISPLAY SETUP" screen shown is for dual engines. Triple and quad
applications will show three fields. The third field will be listed as "CENTER" location. Single
engine applications will have one field.