Mercury Racing VesselView, Инструкция по установке, калибровке и эксплуатации

Страница: 86 / 190

Section 4 - Main Menu
90-8M8022154 APRIL 2008 Page 79
11. Press the up arrow on the arrow trackpad to highlight the "ACTUAL MAX TRAILER"
field.
32745
12. Press the left or right arrow on the arrow trackpad to adjust the "ACTUAL MAX
TRAILER" trim percentage to match the "CURRENT ACTUAL %".
13. Press the check button to go back to the main trim calibration screen. VesselView will
show that it is "Working".
14. Perform steps 2 through 13 for all remaining engines or drives on the vessel.
15. Press the
X
button two times to exit trim calibration.
NOTE: Upon completing any change/customization to VesselView a blue pop‑up message
will appear as a reminder to save your session. Refer to
Section 1 - Saving Settings
. To
save time, it is recommended that all session changes be saved before holding
X
button
while keying ALL engines off.
Configuration
The "Configuration" menu is where you would go to
identify your engine type
. This menu
option enables an advanced user to assign the VesselView it's unique ID, define the
number of engines, and where the engine data should be displayed on the VesselView
screen. Novice user's should use the setup wizard to alter the aforementioned data. Refer
to
Section 2 - Setup Wizard
.
NOTE: The configuration menu option does not need to be performed if the vessel has
been configured using the setup wizard. The "Configuration" menu option enables
adjustment to the existing configuration and offers a quick review of the current settings.