Mercury Racing VesselView, Инструкция по установке, калибровке и эксплуатации

Страница: 30 / 190

Section 2 - Initial Setup and Calibration
90-8M8022154 APRIL 2008 Page 23
NOTE: If there are more engines on the vessel than you wish to display, choose "NONE"
for those engine locations.
27200
a
b
a - Right side location
b - Left side location
2. Press the left or right arrow on the arrow trackpad to scroll through the available
locations. You may select any of the following, depending on the number of engines:
•
"NONE"
• "STBD"
• "PORT"
• "CENTER" (triples only)
• "STBDCNTR" (quads only)
• "PORTCNTR" (quads only)
3. If there are multiple engines, press the down arrow on the arrow trackpad to proceed
to the next field.
4. Perform steps 1, 2, and 3 for all remaining engines on the vessel.
5. Confirm your selections by pressing the check button.
6. Press the right arrow on the arrow trackpad to continue to the "DEVICE SETUP" screen.
Device Setup
The unique VesselView ID differentiates each VesselView unit from all other installed
SmartCraft devices, such as other VesselView units or SmartCraft gauges. The "DEVICE
SETUP" screen enables you to assign this unique identifier to each VesselView unit and
to designate whether the VesselView is installed at the primary or secondary helm.
IMPORTANT: Do not choose the same Unique VesselView ID for multiple VesselView
installations.
1. If there is only one VesselView unit installed on the vessel, proceed to step 5; otherwise,
press the check button to access the "UNIQUE VESSELVIEW ID" field.