Mercury Racing VesselView, Инструкция по установке, калибровке и эксплуатации

Страница: 102 / 190

Section 4 - Main Menu
90-8M8022154 APRIL 2008 Page 95
4. The fuel critical level default setting is 10% and can be increased by pressing the right
arrow on the arrow trackpad.
NOTE: The fuel critical level percentage cannot be set below 10% or higher than the fuel
low level percentage.
5. Press the down arrow on the arrow trackpad to proceed to the "FUEL LOW LEVEL"
field.
6. The fuel low level default setting is 25% and can be increased by pressing the right
arrow on the arrow trackpad. The highest you may set the fuel low level is 50%.
NOTE: The fuel low level percentage cannot be set below the fuel critical level percentage.
7. Once you have finished adjusting your warnings, press the check button to save the
session.
NOTE: Upon completing any change/customization to VesselView a blue pop‑up message
will appear as a reminder to save your session. Refer to
Section 1 - Saving Settings
. To
save time, it is recommended that all session changes be saved before holding
X
button
while keying ALL engines off.
Units
The "UNITS" screen enables you to set the units of measure for speed, depth, distance,
temperature, and pressure. Menu path: "Main" > "Settings" > "Units". Press the check
button to open the "UNITS" screen.
a
b
c
d
e
27317
a - Speed
b - Depth
c - Distance
d - Temperature
e - Pressure
1. Upon entering the "UNITS" screen, the "SPEED" field will be highlighted in blue.
2. Press the left or right arrow on the arrow trackpad to select speed units of "MPH",
"KMH", or "Knots".
3. Press the down arrow on the arrow trackpad to proceed to the "DEPTH" field.
4. Press the left or right arrow on the arrow trackpad to select depth units of "FT", "FTM",
or "Met".
5. Press the down arrow on the arrow trackpad to proceed to the "DISTANCE" field.