Mercury Racing VesselView, Инструкция по установке, калибровке и эксплуатации

Страница: 87 / 190

Section 4 - Main Menu
Page 80 90-8M8022154 APRIL 2008
Menu path: "Main" > "Calibrate" > "Configuration". Press the check button to open the
configuration screen.
a
b
c
d
e
f
g
27128
a - Power package name
b - "HELM ID" ‑ Identifies the helm location of the VesselView
c - "DEVICE ID" ‑ Unique identifier for the VesselView unit
d - "NUM ENGINES" ‑ Number of engines
e - "RIGHT SCREEN" ‑ Engine data displayed on the right side of the screen
f - "LEFT SCREEN" ‑ Engine data displayed on the left side of the screen
(multiple engines only)
g - "CENTER SCREEN" ‑ Engine data displayed on the center of the screen
(triple and quad engines only)
NOTE: The power package can only be changed in the setup wizard. Perform a factory
reset to change the power package and go to the setup wizard. Refer to
Section 4 - Factory
Reset
.
1. The "HELM ID" field will be highlighted when the configuration screen is first entered.
Use the right and left arrow on the arrow trackpad to select the helm identification
number.
2. Press the down arrow on the arrow trackpad to proceed to "DEVICE ID".
3. Use the right and left arrow on the arrow trackpad to select the device id number.
4. Press the down arrow on the arrow trackpad to proceed to "NUM ENGINES".
5. Use the right and left arrow on the arrow trackpad to select the number of engines.
6. Press the down arrow on the arrow trackpad to proceed to "RIGHT SCREEN".
7. Press the left or right arrow on the arrow trackpad to scroll through the available location
types. You may select any of the following, depending on the number of engines:
•
"NONE"
• "STBD"
• "PORT"
• "CENTER" (triples only)
• "STBDCNTR" (quads only)
• "PORTCNTR" (quads only)