Mercury Racing VesselView, Инструкция по установке, калибровке и эксплуатации

Страница: 157 / 190

Section 8 - Installation and Wiring
Page 150 90-8M8022154 APRIL 2008
2. Use an angled flat head screwdriver to pry the bezel off at one of the access slots.
27440
3. Move to the next access slot and proceed to pry the bezel off.
4. When the bottom of the bezel is loose, pry up the sides of the bezel with the screwdriver
until the bezel releases.
DTS Wiring Guidelines
!
WARNING
Splicing or probing will damage the wire insulation allowing water to enter the wiring.
Water intrusion may lead to wiring failure and loss of throttle and shift control. To avoid
the possibility of serious injury or death from loss of boat control, do not splice or probe
into any wire insulation of the DTS system.
• Never attempt to connect, network, tie into, switch, sink source voltage or current from
the DTS wiring harnesses.
• Never attempt to connect any type of communication or navigation equipment into the
DTS wiring harnessing other than at the designated connection point.
• Always install boat accessory equipment using an appropriate power source
connection, such as a fuse panel or junction box.
• Never attempt to tap directly into any of the DTS electrical wiring harnesses for a source
of power.
Wiring Guidelines for Electrical Boat Accessories
!
WARNING
Excessive voltage drop may compromise the DTS system, leading to serious injury or
death from loss of throttle and shift control. Do not wire any electrical accessory into the
12‑volt ignition key switch circuits of the DTS system.
IMPORTANT: Do not connect boat accessories to the ignition key switch. Use a separate,
switched 12‑volt source for wiring boat accessories.
IMPORTANT: The DTS system requires a consistent 12‑volt power source. Splicing or
connecting accessories to the 12‑volt or ignition key switch DTS circuits (purple, purple/
white, or red wires) could blow a fuse or overload circuits, causing intermittent or complete
loss of operation.
Harness Installation Guidelines
IMPORTANT: A SystemView harness is NOT compatible with VesselView. VesselView
must only be installed using the harness contained in the VesselView kit.