Kantronics KPC-9612 Plus, Руководство пользователя

Страница: 272 / 348

PAGEDIR {n|LIST[call|alias|capcode]| {+|-} callsign
[alias] [-A|-N] [-512|-1200|-2400] [-P] capcode }
(max value of n depends upon RAM)
This command is used to allocate memory for n entries for the page directory, to
list the contents of the directory, or to make entries into the directory. The direc-
tory simplifies paging by allowing nicknames (aliases) or callsigns to be
subtituted for a pager’s 7-digit capcode (address) when entered a page at the key-
board or via the Page Server (via packet connect). In order to accomplish this, the
directory is a table of information about each pager entered, containing the fol-
lowing for each: callsign, optional nickname, signal format (numeric or alpha),
message rate, optional security flag, and pager’s actual capcode.
+ For details on the use of this command, see the material on Page Directory in the
Paging section of the Modes of Operation.
See also: pagepswd, pagepriv
PAGELOG {n|LIST|CLEAR} (maximum value of n depends
on RAM)
default 0
This command is used to allocate n Kbytes of memory for the page log, to list the
contents of the log, and to clear the log. Allocating memory, i.e. using the nu-
meric parameter, will cause the 9612 Plus to reset. To clear the log but retain the
memory allocated without a reset use ‘clear,’ and to list the log, use ‘list.’ If the
pagelog fills up completely, the oldest entry is lost when the next page is initi-
ated.
+ The format of the pagelog list is shown in the Paging section of the Modes of Op-
eration.
PAGEMON {ON|OFF|cccc}
(each c must equal N, A, X, or Z)
default OFF.
Command Reference TNC Commands
User’s Guide 256 KPC-9612 Plus v 8.2