Kantronics KPC-9612 Plus, Руководство пользователя

Страница: 111 / 348

TRANS (Transparent) Mode
A second way to transmit data is to instruct the KPC-9612 Plus to ignore the
“control characters” (e.g., “backspace”) and just transmit every character as data.
This is called the “TRANS” (transparent) mode of communication. For example,
if data received by the KPC-9612 Plus for transmission in TRANS mode includes
“backspace” characters (i.e., characters that would cause a backspace in
CONVERS mode), the KPC-9612 Plus will transmit the backspace characters as
part of the data.
+ Before you can switch to TRANS mode, you need to set INTFACE to
TERMINAL instead of NEWUSER. (This is because, as described in the next
section, the TRANS command is not a NEWUSER command.) To get out of
TRANS mode and back to COMMAND mode, enter “<Ctrl+C> three times,with
a pause of less than one second between each entry.
TNC Commands
You have a choice of whether to have your KPC-9612 Plus prepared to deal with
a small set of (22) NEWUSER commands (which is the default setting) or with
the full set of over 130 commands it is capable of carrying out.
+ Note: To switch to the full command set of the KPC-9612 Plus, get in COM-
MAND Mode (<Ctrl+C> or press F9 in Pacterm) and give the command
INTFACE TERMINAL. To switch back, give the command INTFACE
NEWUSER.
NEWUSER Commands
The following diagram shows all the NEWUSER commands and summarizes
each command.
TNC Commands Getting Started
KPC-9612 Plus v 8.2 95 User’s Guide