Kantronics KPC-9612 Plus, Руководство пользователя

Страница: 238 / 348

CSTAMP {ON | OFF}
default OFF
When ON, the daytime stamp is printed with all “*** CONNECTED TO” and
“*** DISCONNECTED” messages on the terminal.
See also: connect, daytime, disconnect, mstamp
CTEXT text (0 - 128 characters)
default (blank)
CTEXT specifies the text of the first packet to be sent in response to an accepted
connect request provided that the parameter CMSG is not OFF. Enter any combi-
nation of characters and spaces up to maximum length of 128. Entering a single
“%” will clear CTEXT.
See also: cmsg, connect
CTRL [A | B] {n | ON | OFF | LONG} (n=1-20)
Multi-Port
immediate
This command controls the status of two output (control) lines (A and B) at each
port (1 and 2). Each line may be set high, low, pulsed once for 1.5 seconds, or
pulsed “n” times where each pulse is 0.1 second in duration. These control lines
can be used for whatever your imagination can dream up.
For example, you might locate the TNC at a remote site, connect to it’s remote
call sign, MYREMOTE, and then use this command (in the TNC at the remote
site) to pulse control line A on port 1 for 1.5 seconds to reset a piece of equip-
ment. In this case, you would issue the command CTRL A2/.
Or, to pulse the B output of port 2 three times, you’d issue the command CTRL B
/3. If you do not specify A or B both lines are affected, and if you do not specify
a port (by using the “/” character) lines in both ports are affected.
Command Reference TNC Commands
User’s Guide 222 KPC-9612 Plus v 8.2