Kantronics KPC-9612 Plus, Руководство пользователя, Страница: 216 / 348

The availability of the commands listed here depends upon what INTFACE
(i.e., INTERFACE) mode the TNC is currently in (see the INTFACE
command in the command listing below and check the index for more informa-
tion on INTFACE modes).
Format for Listing Commands
All TNC commands are listed alphabetically below.
A “
#
” bullet in front of the name of a command indicates that the command is a
NEWUSER Command — it will be available for use when the TNC is set to
NEWUSER Mode.
The TNC ships with NEWUSER as the default INTFACE mode. Also, the TNC
will be in NEWUSER mode after a hard reset.
Format Defining Commands
The Command Line
The first line of each command definition shows the syntax for entering the com-
mand, beginning with the name of the command, followed by a listing of any pa-
rameters that may be used with the command.
The full name of each command is shown in CAPS and a “short-form” of the
command is shown by the underlined characters in the name. The short-form of
the command is the shortest string of characters, starting from the beginning of
the full name, that will allow the TNC to uniquely identify the command being
requested.
The TNC scans an internal list of commands — which is NOT in alphabetical order
— and selects the first match with the string you enter.
The command name is followed by a space.
After the space, there may be one or more parameters that need to be used, or that
may optionally be used, with the command.
Command Reference Introduction
User’s Guide 200 KPC-9612 Plus v 8.2