Kantronics KPC-9612 Plus, Руководство пользователя

Страница: 299 / 348

XKCHKSUM {ON | OFF}
default OFF
This command only applies when INTFACE is set to XKISS. The value of
XKCHKSUM controls whether or not the XKISS CHECKSUM mode is active.
See also: xkpolled
XKPOLLED {ON | OFF}
default OFF
This command only applies when INTFACE is set to XKISS. XKPOLLED con-
trols whether or not the XKISS POLLED mode is active.
See also: xkchksum
XMITLVL n (n = 0-502)
Multi-Port
default 100/64
This command may be used to set the modem drive level for ports 1 and 2. You
may find it more convenient to use the CAL command in that it allows you to
continuously adjust drive level by holding down the + or - key while in cali-
brate mode.
For port 1, the voltage range set by the XMITLVL command is from 1 mV to 4 V
p-p. From a count of 0 to 255, the voltage is increased from 1 mV to (approxi-
mately) 130 mV, or 0.50 mV per step. From a count of 256 and above, the volt-
age is increased linearly but in larger steps (approximately 15 mV per step) until
4 volts (max) is reached at a count of 502.
For port 2, the voltage range is set linearly by the XMITLVL command (count of
0 to 255) from 2 - 100 mV p-p if jumper J20 is Off and from 80 mV to 4 V p-p if
J20 is ON (i.e. jumper on both pins, which is the factory default placement).
Most high-speed radios prefer the high (default) drive.
TNC Commands Command Reference
KPC-9612 Plus v 8.2 283 User’s Guide