Kantronics KPC-9612 Plus, Руководство пользователя, Страница: 285 / 348

See also: ax25l2v2, frack, relink, tries
RING {ON | OFF}
default ON
When ON, three bell characters ($07) are sent to the terminal with each “***
CONNECTED TO” message (when another station initiates the connect).
RNRTIME n (n = 0 - 255)
default 0
RNRTIME is set in 10 second increments. If a connection stays in a remote de-
vice busy state (continues to receive RNR frames) for RNRTIME, the TNC will
disconnect. If a KA-Node connection stays in a remote device busy state for
RNRTIME the KA-Node will disconnect the input and output sides of the
KA-Node circuit. Setting RNRTIME to 0 disables this function.
See also: mresp
RPRINT text (text up to about 250 characters)
immediate
This is an immediate command which sends the “text” string to the device at-
tached to the TNC RS232 port (e.g. to a GPS unit or Repeater controller). It is in-
tended to allow a remote SYSOP (a station situated remotely from, but connected
to, the TNC using the MYREMOTE callsign of the TNC) to send a string to a
unit attached to the TNC serial port. For example, the string content could be
used to change the configuration of a GPS unit, or to change configuration or set-
tings in a Repeater controller (not available when the TNC INTFACE is set to
HOST, KISS or MODEM mode).
TNC Commands Command Reference
KPC-9612 Plus v 8.2 269 User’s Guide