Kantronics KPC-9612 Plus, Руководство пользователя

Страница: 269 / 348

NUMNODES n (n = 0-26, depending on available RAM)
default 0
This command is used to set the number of allowable circuits through the
KA-Node. For example, if you wish to allow up to 3 simultaneous circuits
through the node, set NUMNODES 3.
+ Changing the value of NUMNODES will cause a soft reset.
Approximately 4K of RAM is used for each circuit. The amount of RAM avail-
able will depend on how much RAM has been used for the PBBS, MAXUSERS,
and MYREMOTE parameters. If you select n larger than available RAM will al-
low, a “Not enough RAM” message will be returned to you. Generally, set the
amount of RAM required first for your PBBS (personal bulletin board) and then
set the desired number of circuits. For example, if you have 32K RAM and n is
set to 5 you can only have a 1K mailbox. In this case, if n is larger than 5, a ‘mes-
sage saying “not enough RAM” will be returned to you.
Note: While you need to enter all the letters of the command name to change the
value of NUMNODES, you can enter the short-form, NU, to see the current value
of NUMNODES.
See also: mynode; KA-Node section
ONERADIO {ON | OFF}
default OFF
When ON, the presence of carrier detect on either of the two radio ports will pre-
vent both ports from transmitting (if FULLDUP is OFF). This can be used to op-
erate two modems (e.g., 1200 and 9600) on one frequency. When OFF, each port
of the TNC detects presence of a signal independent of the other port.
See also: cd
TNC Commands Command Reference
KPC-9612 Plus v 8.2 253 User’s Guide