Kantronics KPC-9612 Plus, Руководство пользователя, Страница: 222 / 348

TNC Commands
All TNC commands are documented below, in alphabetical order. The underlined
characters in a command’s name show the short-cut version of the command. Re-
quired or optional parameters are shown after the command name, as are allow-
able ranges of values, where appropriate.
8BITCONV {ON | OFF}
default ON
This command provides for the use of 8-bit data in Convers Mode. When ON,
transmission of 8- bit data is allowed in Convers Mode; if OFF, the 8th bit is
stripped (set to 0) for transmission and all data received will have the 8th bit set
to zero (0). KA-Node, digipeat, and PBBS operations are unaffected by any use
of this command.
See also: trans
ABAUD n (n =
0,300,600,1200,2400,4800,9600,19200,38400)
default 0
The parameter n sets the baud rate used for input and output through the serial
RS232 port of the TNC to a computer. If 0 is used, the TNC will run an autobaud
routine upon power-up. This routine looks for an asterisk (*) character from the
attached computer to set the ABAUD parameter.
If you wish to use a different baud rate, or to perform autobaud the next time the unit is
powered up, you must change the ABAUD parameter. If you change the baud rate in your
computer or terminal you should change the baud rate in the TNC first, then issue the
RESET command, then set the new baud rate on your computer. Otherwise a hard reset
will be required to erase the ABAUD setting and reinitialize the TNC to perform the
autobaud routine. (See Hard Reset section.) Note also that a hard reset will erase ALL
stored parameters in your TNC and return them to factory defaults.
See also: reset, restore
Command Reference TNC Commands
User’s Guide 206 KPC-9612 Plus v 8.2