IBM Cloud Object Storage System Slicestor 2212..., Руководство по обслуживанию и ремонту

Страница: 63 / 197

| Note: If the new chassis has a blower without a wired connector and the
| blower from the old chassis has a blower with a wired connector, install
| the blower with the wired connector, in the new chassis using the
| instructions in “Exchanging a Blower in Models 4xx” on page 2-6.
7. Attach the hard drive to the base of the chassis with its four screws.
8. Reinstall the cover of the IBM 2212 using the instructions in “Reinstalling the
Cover” on page 2-5.
9. Install the system card and adapters.
10. Attach an ASCII terminal to the IBM 2212 as described in Chapter 3,
“Accessing the IBM 2212” on page 3-1.
11. Power on the IBM 2212 by plugging in the power cord.
12. Access the SVC> prompt. (See “Accessing the Service Recovery Prompt
(SVC>)” on page E-4.)
13. Enter into Vital Product Data (VPD) the serial number of the defective IBM
2212 chassis. The serial number is printed on the back of the IBM 2212. For
instructions on entering the serial number into the VPD, see “Entering Vital
Product Data” on page E-14.
14. Type reboot.
15. Verify the LEDs. See “LED Indicators” on page 1-2.
16. Reference the serial number recorded from the old chassis and write this serial
number on a label. Also write the chassis model number on the label. Post this
label on the exterior of the new chassis.
17. Notify the network administrator that you are finished.
Chapter 2. Removal and Replacement Procedures
2-35