IBM Cloud Object Storage System Slicestor 2212..., Руководство по обслуживанию и ремонту

Страница: 55 / 197

| c. Reinstall the blower to the chassis with the screws and washers.
5. Connect the dc power cable to the backplane at the 6-pin connection. Connect
the blower and fan connector cables to the backplane at either 2-pin
connection.
6. Connect the hard drive power cable and IDE cable to the hard drive.
7. Attach the hard drive to the base of the chassis with its four screws.
8. Reinstall the cover on the chassis using the instructions in “Reinstalling the
Cover” on page 2-5.
9. Install the system card and adapters.
10. Attach an ASCII terminal to the IBM 2212 as described in Chapter 3,
“Accessing the IBM 2212” on page 3-1.
11. Power on the IBM 2212 by plugging in the power cord.
12. Access the
SVC>
prompt. (See “Accessing the Service Recovery Prompt
(SVC>)” on page E-4.)
13. Enter into Vital Product Data (VPD) the serial number of the defective IBM
2212 chassis. The serial number is printed on the back of the IBM 2212. For
instructions on entering the serial number into the VPD, see “Entering Vital
Product Data” on page E-14.
14. Type reboot.
15. Verify the LEDs. See “LED Indicators” on page 1-2.
16. Reference the serial number recorded from the old chassis and write this serial
number on a label. Also write the chassis model number on the label. Post this
label on the exterior of the new chassis.
17. Notify the network administrator that you are finished.
Chapter 2. Removal and Replacement Procedures
2-27