IBM Cloud Object Storage System Slicestor 2212..., Руководство по обслуживанию и ремонту

Страница: 143 / 197

Adapter Tasks
Adapter Status / LED States
Question How do I check the state of the adapters in my IBM 2212?
Answer LEDs on the front and rear of the IBM 2212 indicate the status of the adapter. (See “Adapter
Port LEDs” on page 1-4 and “Additional Slot-Status LEDs” on page 1-8.)
Adding an Adapter After Initial Configuration
| Note: The compression/encryption adapter is a coprocessor (cpr) interface, not a net interface.
Question How do I add an adapter after the IBM 2212 has been initially configured?
Answer Install the adapter using the instructions accompanying the feature. Either use the
Configuration Program and download the updated configuration to the IBM 2212, or follow
these steps to configure adapters using the IBM 2212’s OPCON command line interface (
*
prompt).
1. Access the OPCON command line interface (
*
prompt). See “Accessing the OPCON
Command Line Interface” on page E-2.
2. Type talk 6 and press Enter to reach the
Config
>
prompt. If the
Config
>
prompt does not
appear, press Enter again.
3. Type add device type of device and press Enter.
To see a list of device choices, type add device ? and press Enter.
The following two steps do not apply when a dial-circuit device is being added.
4. Enter the device slot number. If you add a PMC adapter or configure a Model 1xF or 1xH,
you will not be prompted for a slot number.
5. If you are adding an interface on a single-port adapter, go to step 6. Otherwise, continue
with this step.
Enter the port number. The range of port numbers supported depends on the multi-port
adapter type.
6. Make a note of the interface number to which this port is assigned and the net number. If
you configure a WAN interface and wish to use a data-link type other than PPP, you must
use the set data-link
data-link type command to change the data-link type to any of the
data-link protocols available on your IBM 2212 (frame relay, X.25, and SDLC for example).
7. Enter at the
Config>
prompt net net number to access interface-unique configuration
commands. Refer to the Access Integration Services Software User’s Guide for a
description of the supported interface commands.
| Note: This step does not apply to the compression/encryption adapter. At the
Config>
| prompt, enter enable coprocessor to enable the compression/encryption adapter.
8. Enter exit after configuring the interface.
| Note: This step does not apply to the compression/encryption adapter.
9. Use the protocol command at the Config> prompt to configure protocols on the interface.
Refer to Volume 1 and Volume 2 of the Access Integration Services Protocol Configuration
and Monitoring Reference for a description of the supported commands for each protocol.
10. Enter exit to get the
Config
>
prompt.
Appendix E. Common Tasks
E-5