IBM Cloud Object Storage System Slicestor 2212..., Руководство по обслуживанию и ремонту

Страница: 41 / 197

|
¹
DRAM (See “Exchanging a DRAM Feature on a Standard System Card” on
| page 2-19.)
|
¹
PMC adapter (See “Exchanging a PMC Adapter” on page 2-7.)
|
¹
Compact flash, if compact flash is installed on the system card (See
| “Exchanging a Compact Flash Feature” on page 2-22.)
| 5. Return the standard system card as indicated in the warranty for your country.
| 6. Install the DRAM, PMC adapter, and compact flash components on the new
| standard system card. See “Exchanging a DRAM Feature on a Standard
| System Card” on page 2-19, “Exchanging a PMC Adapter” on page 2-7, and
| “Exchanging a Compact Flash Feature” on page 2-22 for installation
| instructions.
| 7. Slide the new card along the grooves in the slot and secure the two levers. To
| lock the card into place, pull each lever inward.
| 8. Reattach the cables to the standard system card.
| 9. Power on the IBM 2212 by plugging in the power cord.
| 10. Verify the LEDs. See “LED Indicators” on page 1-2.
| 11. Connect an ASCII terminal or a PC with ASCII terminal emulation software
| configured to use 19.2 Kbps line speed, and access the
SVC>
prompt.
| See “Accessing the Service Recovery Prompt (SVC>)” on page E-4.
| 12. At the
SVC>
prompt:
|
¹
Use the describe command to list the contents of the banks on the hard
| file or compact flash. Choose a bank to make active.
|
¹
Use the set command to set the active bank and configuration file (config).
| After typing set and pressing Enter, you will be prompted for the rest of the
| information. Until you reboot, this bank will be in the pending state.
|
¹
Use the writeos command to copy the abbreviated software (used as the
| recovery image) from the pending bank on the hard file/compact flash to
| the new standard system card flash.
| See “Updating the Operational Code” on page E-23.
|
¹
Use the writeboot command to copy the bootstrap code from the pending
| bank on the hard file/compact flash to the new standard system card flash.
| See “Updating the Operational Code” on page E-23.
|
¹
Use the interface command to reconfigure the interface to dump over if
| you want to use the network dump facility.
|
¹
Use the bootmode command and select normal boot from disk.
|
¹
Use the dump command to reconfigure the dump information. After typing
| dump and pressing Enter, you will be prompted for the rest of the
| information.
|
¹
Use the baudrate command to reset the baudrate for the IBM 2212 service
| port if you wish to use a speed other than 19.2 Kbps. After typing baudrate
| and pressing Enter, you will be prompted for the rest of the information.
|
¹
Unplug and plug the power cord on the IBM 2212.
Chapter 2. Removal and Replacement Procedures
2-13