IBM Cloud Object Storage System Slicestor 2212..., Руководство по обслуживанию и ремонту

Страница: 108 / 197

Testing the Adapters
‡ —
Screen 1 of 1
Select Test Setup
10/100 Mb Ethernet PMC Adapter, Slot 5, Net # 0
Operational Status Diagnostic Status Fault Status Network Connection
DIAGNOSTICS MESSAGE OK UNKNOWN
This device may be tested with or without a wrap plug.
* < 1. Start testing without a wrap plug. >
* < 2. Start testing with a wrap plug installed. >
Select (1-2 or B=Back ):
7. Label and disconnect the cable for the adapter. Type 1 and press Enter if you
are not installing an external wrap plug. If you choose 2, you must install an
external wrap plug on the adapter.
| 8. This is a long-running test. The Device Status and Control Menu is displayed
| again. Note that the Diagnostic Status is TESTING. This indicates that the tests
| are running and will take about three minutes to complete. (If you have
| software code Version 1.0 refer to the first screen. Refer to the second screen
| if you have software code Version 2.0.)
|
‡
|
—
|
Screen 1 of 1
|
Device Status and Control
|
10/100 Mb Ethernet PMC Adapter, Slot 5, Net # 0
|
Operational Status Diagnostic Status Fault Status Network Connection
|
DIAGNOSTICS TESTING OK UNKNOWN
|
0%
|
Select from the following:
|
Disable Device
|
Enable Device
|
Run Default Test
|
Run Interactive Test
|
Loop Test - stop on first error
|
Loop Test - Log all errors
|
Stop Looping Test
|
< 1. View Test History Log >
|
< 2. View Hardware Error Log >
|
Select (1-2 or B=Back R=Refresh status H=Help ):
|
Figure 6-7. Device Status and Control Menu, Version 1.0
6-10
2212 Service and Maintenance