IBM Cloud Object Storage System Slicestor 2212..., Руководство по обслуживанию и ремонту

Страница: 144 / 197

11. Repeat steps 3 through 10 if you have a multi-port adapter and you want to have more
than one interface defined on the adapter.
12. Enter write to save your changes.
13. Press Ctrl-p to return to the OPCON (*) prompt.
14. Enter restart at the OPCON ( * ) prompt.
Adding an Adapter at Initial Configuration
| Note: The compression/encryption adapter is a coprocessor (cpr), not a net interface.
Question How do I add an adapter to the software configuration when the IBM 2212 is being initially
configured?
Answer First, perform installation of the 2212 and install any additional adapters into the 2212.
When the IBM 2212 is initially installed, it does not have any software configuration. The
operating system will put you at the
Config only>
prompt.
| Note: These steps create only the interface. Use the net command to configure
| characteristics unique to that interface (for example, T/R, Ethernet, PPP, FR, SDLC,
| X.25). (If the device is a coprocessor, then use the enable coprocessor command to
| enable the coprocessor.) You also need to use the protocol command to configure
| protocols on the interface.
| If you configure a WAN interface and you want to use a data-link type other than PPP,
| use the set data-link data-link type command to change the data-link type to any of the
| data-link protocols available on your IBM 2212 (frame relay, X.25, and SDLC for
| example).
1. Enter add device type of device
To see a list of device choices, type add device ?.
If you are adding a dial-circuit device, go to 4. Otherwise, continue with the following step.
2. Enter the device slot number. If you add a PMC adapter or configure a Model 1xF or 1xH,
you will not be prompted for a slot number.
3. If you are adding an interface on a single-port adapter, go to step 4. Otherwise, continue
with this step.
Enter the port number. The range of port numbers supported depends on the multi-port
adapter type.
4. Make a note of the interface number to which this port is assigned and the net number.
5. At the Config> prompt enter net
net number to access interface-unique configuration
commands. Refer to the
Access Integration Services Software User’s Guide for a
description of the supported interface commands.
| Note: This step does not apply to the compression/encryption adapter. At the Config>
| prompt, enter enable coprocessor to enable the compression/encryption adapter.
6. Enter exit after configuring the interface.
| Note: This step does not apply to the compression/encryption adapter.
7. Use the protocol command to configure protocols on the interface. Refer to Volume 1 and
Volume 2 of the Access Integration Services Protocol Configuration and Monitoring
Reference for a description of the supported commands for each protocol.
E-6
2212 Service and Maintenance