IBM Cloud Object Storage System Slicestor 2212..., Руководство по обслуживанию и ремонту

Страница: 81 / 197

For instructions about installing SLIP, refer to the documentation for your version of
TCP/IP.
Service Port Default Settings
These are the default settings for the serial port:
Speed 19.2 Kbps
Parity None
Data Bits 8
Stop Bits 1
You can configure the service port speed for the following bit rates; however, the
speed must match the speed configured for the ASCII terminal. See “Changing the
Service Port Speed” on page E-9 for instructions on setting the IBM 2212 service
port speed.
Note: For the initial configuration of the IBM 2212, you must use 19.2 Kbps. As
part of the initial configuration, you can change the line speed of the service
port. See “Changing the Service Port Speed” on page E-9.
¹
2400
¹
9600
¹
14 400
¹
19 200
¹
28 800
¹
38 400
¹
57 600
¹
115 200
Modem Settings
The following modems have been tested for use with the IBM 2212:
¹
IBM 7852, Model 400
¹
Zoom/FaxModem 56Kx
¹
Atlas 33.6 External PC Data/Fax Modem.
|
¹
U.S. Robotics 56K Sportster Modem
| You can use equivalent modems, with a minimum data transfer rate of 2400 line
| speed, with the IBM 2212.
For instructions on setting-up these and possibly other modems to operate with
your IBM 2212, see the general information technical tips available at:
http://www.networking.ibm.com/support/2212
| Note: IBM does not endorse or warranty the performance of any particular modem
| or manufacturer.
Attaching an ASCII Terminal
Attach an ASCII terminal or emulator (with the appropriate emulation software) to
provide local or remote access to the IBM 2212. When locally attaching a terminal
to the IBM 2212 service port, the speed (baud rate) configured for the service port
must match the speed of the connected terminal (x and y in Figure 3-1 on
page 3-2). When connecting a IBM 2212 to a remote terminal by two modems
Chapter 3. Accessing the IBM 2212
3-3