IBM Cloud Object Storage System Slicestor 2212..., Руководство по обслуживанию и ремонту

Страница: 84 / 197

2. Change the values on the selection bar to match the values in Table 3-4 on
page 3-6. To move between selections while on a selection bar, press Tab.
To change a value for an attribute, press the space bar.
3. Press Send to accept the current values for the attributes on the selection bar.
4. Repeat step 2 until you have set all the attributes in Table 3-4.
5. Press Select after the last selection bar to exit the 3161 setup function.
Table 3-4. Additional Setup Attributes for the IBM 3161
Attribute Setting
Enter Send
Return Field
New Line CR
Tab Field
Line Wrap On
Auto LF Off
Send Null On
Insert Space
Trace All
CRT Saver No
Scroll On
Print Viewport
Print Null On
Print EOL On
Line End CR-LF
Send Line
Bringing Up a Command Line Console
After you have connected your console to the IBM 2212, and have powered on the
console and the IBM 2212, you will see a sequence of informational status
messages. When you see the prompt
Please press the space bar to obtain the
console , press the space bar to attach the IBM 2212 to your session. The system
acknowledges this action with the message Console granted to this interface ,
and by displaying a command prompt after the code loading is complete.
If you are at an IBM 2212 that has never been configured, the system presents the
command prompt
Config (only)>
. You can then proceed with the initial
configuration. If the IBM 2212 has been configured adequately, the system presents
the OPCON command prompt (
* ).
If the IBM 2212 determines during the boot process that the operational code on
the hard drive or compact flash is unusable, it will boot to the service recovery
function (
SVC>
prompt). The full operational code is not loaded and only the
commands needed to restore the IBM 2212 hard drive or compact flash to an
operational state are available. The
SVC> prompt can also be manually accessed as
described in “Accessing the Service Recovery Prompt (SVC>)” on page E-4. See
the
Access Integration Services Software User's Guide for a complete list of the
commands.
3-6
2212 Service and Maintenance