Result
After the interface data and the PSTN user data corresponding to the MG interface are configured
on the MGC, check whether the VoIP service can be provided normally. In normal cases, phone
0-phone 31 can call each other.
l
The calling party can hear the dial tone after picking up the phone off the hook.
l
When the calling party dials the phone number of the called party, the phone of the called
party can ring normally, and the calling party can hear the ringback tone.
NOTE
When the calling party calls the number of a specified user, if the phone of the specified user does
not ring but the phone of another user connected to the MA562X rings, and the calling party hears
the ringback tone, check whether the MGC is configured with the call forwarding service, causing
the line cross.
l
If the MGC is configured with the call forwarding service, cancel the call forwarding service on
the MGC.
l
If the MGC is not configured with the call forwarding service, contact Huawei technical support
engineer to handle the fault.
l
The calling party and the called party can communicate with each other normally.
l
After the called party places the phone on the hook, the calling party can hear the busy tone.
Configuration File
The following part describes the configuration file of this configuration example. Note that
certain steps must be performed manually and the configuration file cannot be imported directly.
Configure the upstream VLAN interface.
vlan 20 standard
port vlan 20 0/0 0
interface vlanif 20
ip address 10.10.10.10 24
Configure the media and signaling IP address pools.
quit
voip
ip address media 10.10.10.10 10.10.10.1
ip address signaling 10.10.10.10
Add an MG interface and then configure the attributes of the MG interface. An MG interface
must be added manually and the configuration file cannot be imported directly.
quit
interface h248 0
if-h248 attribute mg-media-ip1 10.10.10.10 mgip 10.10.10.10 mgport 2944 primary-
mgc-ip1
10.10.20.20 primary-mgc-port 2944 code text transfer udp start-negotiate-version 0
Configure the ringing mapping of the MG interface.
mg-ringmode add 0 0 4
Configure the TID template of the PSTN user on the MG interface.
tid-format pstn prefix huawei template 6
An MG interface must be started manually and the configuration file cannot be imported directly.
reset coldstart
SmartAX MA5616 Multi-service Access Module
Configuration Guide
8 Configuration Example of Services on the MA5616
Through GPON Upstream Transmission
Issue 04 (2011-10-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
357
